VEHICLE DEVICE
68
HANDLEBAR ADJUSTMENT
The handlebars can be adjusted to suit the rider's angle.
!
WARNING
Improper adjustment of the handles or improper torque of tightening
bolts can result in limited or loose of handler steering, loss of control
can result in severe injury or death. Always follow the adjustment
procedure, or check out the services at your dealer.
1
M8×48 (4 PCS)
Torque to specifi cation
：
Torque
Handlebar bolts
: 29N.m (21.4ft·lb)
1. Loosen the four handlebar bolts.
2. Adjust the position of the handlebar according to the rider
needs.
3. Tighten the two front bolts and then tighten the two rear bolts.
Leave a gap of 1/8 (3 mm) at the back of the clamp block.
4. Tighten the fastening bolts.
To Next Page
Loading...
