Seiko 1B21 - How to Use Tri-Fold Type Clasp for Leather Band (Special Clasps)

How to use tri-fold type clasp for leather band (Special clasps)
There are 3 types of special clasps as described below;
If the clasp of the watch you purchased is one of them, please refer to the indications.
A A Type → P.53
B B Type → P.54
C C Type → P.55
EN
52
6
TO PRESERVE THE QUALITY OF YOUR
WATCH
A A Type
1
Lift up the clasp to release the buckle.
Fixed loop
Movable loop
Buckle
Flap
2
Open the flap.
3
Remove the pin from the adjustment hole. Slide the
band left and right, and reinsert the pin into the
adjustment hole at an appropriate length.
Pin
Adjustment hole
4
Fasten the flap.
* Do not push the flap in too hard.
* When fastening the clasp, insert the tip of the band
into the movable loop and fixed loop, and then,
securely tighten the clasp.
EN
53
6
TO PRESERVE THE QUALITY OF YOUR
WATCH
B B Type
1
While pressing the push buttons on both sides
of the flap, lift to open the clasp.
Push button
2
Remove the pin from the adjustment hole.
Slide the band left and right, and insert the pin
into the adjustment hole at an appropriate
length. Push the buckle and fasten the clasp.
Buckle
Pin
Adjustment hole
EN
54
6
TO PRESERVE THE QUALITY OF YOUR
WATCH
C C Type
●
How to wear or take off the watch
1
While pressing the push buttons on both sides
of the flap, pull the band out of the movable
loop and fixed loop. Then open the clasp.
Fixed loop
Movable loop
Buckle
Flap
Push button
2
Place the tip of the band into the movable loop
and fixed loop, and fasten the clasp by
pressing the frame of the buckle.
EN
55
6
TO PRESERVE THE QUALITY OF YOUR
WATCH