Seiko 7B24 - HowToSetThePreliminaryPosition; SettingThePreliminaryPositionOfTheDate

144
Troubleshooting
Howtosetthepreliminaryposition
■ Settingthepreliminarypositionofthedate
Whensettingthepreliminarypositionofthehourandminute
handsrightaftersettingthepreliminarypositionofthedate,
aftercompletingprocedure2ofpreliminarypositionsetting
ofthedate,gotoprocedure2onpage147.
Thepreliminarypositionofthedateisthe“1st.”
Whenthepreliminarypositionofthedateis
incorrect,thecorrectdatecannotbedisplayed
evenifthewatchreceivesaradiosignal.
Lossorgainofthedatecanbeadjustedby
settingthepreliminarypositionofthedateas
the“1st.”
Thedatewillstarttoadvanceandstopatthepreliminaryposition.
PressandholdButtonAandButtonBsimultaneouslyuntilthe
secondhandstopsatthe13-secondposition(forfourseconds).
1
ButtonA
ButtonB
PresstheButtons
Simultaneouslyfor
FourSeconds
Inthecasethatthenumericalnumberofthedatedoes
notlocateatthecenterofthewindow,italsocanbe
correctedbythesameproceduresasmentionedabove.
※ PressButtonB
withapointed
object.→page90
※ Neverpullthecrownout.
※ Inordertoperformthe
procedureseasily,itis
recommendedtofirst
pressandholdButtonB,
andthenpressButtonA.
・ Whiledatesareadvancing,nobuttonoperationcanbemade.
・  Afterthedatestops,whenthewatchhasnooperation
andnomovementofthehandsfortensecondsor
longer,itautomaticallydisplaysthetimeagain.
・ Whenitisinthemiddleofoperation,re-attempttheoperationfromprocedure“1.”