59
ASTRON 5X53 GPS SOLAR
FUNCTION LIST/SPECIFICATIONS
8
SPECIFICATIONS
Function for reception
Other functions
In-flight mode ( ) …………………………
P. 3 0
Function to prevent the GPS signal reception
function from working. Set this mode when
boarding an airplane, etc.
Satellite acquisition status display function
…
P. 2 0
Displays by the second hand the number of GPS
satellite from which GPS signals are received
during GPS signal reception.
Reception result display function ………
P. 1 8
Displays the latest reception result (success/
failure).
Time zone setting check function ………
P. 2 5
Displays the currently set time zone
1. Basic function ……………………… Main-dial (hour, minute, and second hands), date
display, day display, indicator function, dual time
display function (with AM/PM hand), world time
function (39 time zones)
2. Frequency of crystal oscillator … 32,768 Hz (Hz = Hertz ... Cycles per second)
3. Loss/gain (monthly rate) ………… Loss / gain ±15 seconds on a monthly rate (When the
watch is used without an automatic time setting by
receiving GPS signal and when it is worn on the wrist
within a normal temperature range between 5°C and
35°C (41ºF and 95ºF)).
4. Operational temperature range … Between −10°C and +60°C (14ºF and 140ºF)
5. Driving system …………………… Step motor: main-dial (hour, minute, and second
hands), day hand, indicator hand and date, sub-dial
(hour, minute, and AM/PM hand).
6. Power source ……………………… Secondary battery, 1 piece
7. Duration of operation …………… Approximately 6 months (Fully charged, and the Power
Save is not activated).
If the Power Save is activated after it is fully charged,
the watch continues to run for approximately 2 years
at maximum.
8. GPS signal reception function … Time zone adjustment, manual time adjustment,
automatic time adjustment
9. IC (Integrated Circuit) …………… Oscillator, frequency divider and driving circuit C-MOS-
IC, 4 pieces
Dual time display function ………………
P. 2 6
The time of an area different from the time of the
main-dial is displayed with the sub-dial at the 6
o’clock position (12-hour) and the AM/PM hand.
Automatic hand position alignment function
…
P. 4 7
Automatically corrects misalignment when the
hands are misaligned due to external factors such
as magnetic influence.
Automatic leap second reception function
…
P. 3 1
Automatically receives leap second data when
leap second data reception is necessary.
Switch function for the main-dial and sub-dial
(Time Transfer Function)
………………………
P. 2 8
Your watch can switch between the times of its
main-dial and sub-dial. It can also switch DST.
Copyright ©2018 by SEIKO WATCH CORPORATION
Declaration of Conformity
The specifications are subject to change without prior notice for product improvement.
To Previous Page
Loading...
Need help?
General