27
3. After the test print, the mode selection message is printed as shown in Figure 10-3.
To return to the print-ready status, select "0 : Normal Mode". (Press the POWER Switch without
pressing the FEED Switch.)
To select other modes, press the FEED Switch the number of times corresponding to the selected
mode number, and then press the POWER Switch.
Figure 10-3 Mode Selection Message
[Mode Select]
0 : Normal Mode
1 : Setting Mode
2 : Change Communication I/F
3 : Hex Dump Mode
Press the FEED switch an equal
number of times to the selected
number. After that, press the
POWER switch.
To Next Page
Loading...
Need help?
General
