3
OPERATING PRECAUTIONS
The "products" shall collectively mean the printer, the cradle, the battery pack and the USB cable.
WARNING
Never attempt the followings. Failure to follow the instructions leads to fire, electric shock, or accident.
DO NOT disassemble or reconstruct the products.
Take care not to spill liquid on the products.
DO NOT touch the products with wet hands.
DO NOT insert any foreign objects such as a piece of metal or any liquid into the products.
Keep the terminals of the products away from dust and metal objects.
DO NOT touch the terminals of the products.
To avoid short circuits, prevent terminals of the products from touching any conductor such as
metal.
Use the printer only with the specified battery pack. If use battery packs other than our specified
product, it may cause leakage, overheating, explosion or fire.
Be sure to charge the battery pack under the specified temperature range. Otherwise, it may
cause leakage, overheating, explosion or fire.
DO NOT expose the printer in a fire and heat it.
DO NOT leave the printer under high temperature conditions such as in scorching heat, inside a
car, or near a fire. It may cause leakage, overheating, explosion or fire.
DO NOT apply strong impact to the printer with a hammer or a nail, and DO NOT crush it.
DO NOT print out during a vehicle driving. Ejected thermal paper may hinder a vehicle driving.
Be sure to observe the following instructions. Failure to follow the instructions may lead fire, electric shock,
or accident.
Be sure to use only in countries where the products meet the regulations.
Using non-compliant products may endanger the safety of products or be considered against
regulations.
Make sure to turn off the printer when installing/removing the battery pack.
To Next Page
Loading...
Need help?
General
