From the main menu, by pressing the key you can
access the statistics:
- T.Pump = operating time of the pump.
- T.Tube = operating time since the last tube replacement.
- Q.Pump = quantity dosed by the pump in liters; this data is
calculated based on the memorized calibration value.
- Activations = number of pump activations.
- Alm.Meas = number of alarms relating to measure.
- Reset = use the key to reset the counters (YES) or
otherwise (NO), then confirm by pressing .
Press the key to return to the main menu.
By setting the password, the programming section can be
accessed to view all the setup parameters, but every time
you try to change the settings you will be prompted for the
password.
The flashing line indicates the editable number; press
to select the number (from 1 to 9), then press to select
the number to modify, and then press to confirm.
By setting “0000” (default), the password will be eliminated.
To Next Page
Loading...