Sekonic Litemaster Pro L-478D - Page 18

18
2) Setting Icons
Setting icons type and value will change with the Measuring mode in use. Touch or
slide nger up/down over the icons to change the value.
T priority mode
CINE mode
F priority mode
HD CINE mode
TF priority mode
Explanation of value types
•
T : Shutter speed
Shutter speed is displayed in the following way.
30m (30 minutes), 8s (8 seconds), 125 (1/125 of a second)
•
ISO : ISO sensitivity
•
F : f-stop (aperture)
•
ANG : Shutter angle
•
f/s : Frames per second (Cine frame rate)
Operating Set Icon:
Value increases when up arrow (▲) is touched.
Value decreases when down arrow (▼) is touched.
Slide the icon number up or down with your ngertip to increase or decrease the
reading.
3) Measuring unit/Displayed value eld
This displays information such as measured values and measuring units.
Measuring value unit: T (shutter speed), F (f-stop), ISO (ISO sensitivity)
Measuring values
Measuring value
Measuring mode information
display
•lx,: Ambientlightilluminance
lx independent display
•fc: Ambientlightilluminance
fc independent display
•cd/m
2:
Ambient light luminance
cd/m
2
independent
display
•: Ambientlightluminance
 independent display
Additional info for measuring value
Example: 1,900,000lx
Flash component
•Theratioofashlighttothetotalexposureisdisplayedasa
percentage (in 10% steps)
Measuring value unit: F (f-stop)