How to troubleshoot a Selden Engine Furlex that is not operating?
If your Selden Engine Furlex is not operating, after furling the sail using the emergency linedriver, troubleshoot the electric system and look for corroded or loose wires in the connection box, as the cause may be an electric failure or bad connection.
What to do if my Selden Furlex Electric Furlex runs in the wrong direction?
If your Selden Engine Furlex runs in the wrong direction, the wires may not have been properly installed. Connect the cables according to the colour codes stated in the manual. If opposite furling direction is wanted: Choose any two of the three motor cables and swap their positions on the connecting box terminal.
Why does my Selden Furlex Electric Engine Furlex stop when heavily loaded?
Your Selden Engine Furlex might stop when heavily loaded due to overload. First, ease the load and check if operation is OK. The motor controller will limit the torque by cutting current supply to the motor, if overloaded. Check the furling system for excessive friction by using the hand operated emergency winding system.
How to fix noise when operating the Selden Engine Furlex?
If you notice noise when operating the Selden Engine Furlex, it may be due to worn gears or a mechanical problem inside the transmission. Dismantle covers and inspect the three gears under the port cover. If their condition is OK, reapply grease and assemble. Hand wind with the emergency socket to check if low speed rotation is without excessive friction or noise.
How to reduce excessive friction in the Selden Furlex Electric furling system?
Excessive friction in the Selden Engine furling system may be due to salt, dirt, and lack of grease. Rinse with freshwater, clean and lubricate the system.
General safety advice and symbols used in the manual for critical warnings.
Detailed step-by-step instructions for assembling the Furlex 204E/304E electric furling system.
Detailed step-by-step instructions for assembling the Furlex 204TDE/304TDE electric furling system.
Step-by-step guide for retrofitting the Furlex 200S/300S with electric drive.
Step-by-step guide for retrofitting the Furlex 200TD/300TD with electric drive.
Step-by-step guide for retrofitting the Furlex 204S/304S with electric drive.
Step-by-step guide for retrofitting the Furlex 204TD/304TD with electric drive.
Procedure for operating the furling system manually in case of electrical failure.
To Next Page
General
