“Dynamic”
Electronic control for towel heaters
Electronic
Via Pacinotti, 24 - 35030 Rubano (PD) Italy- Tel 049.8976761, Fax 049.8976085 - www.selmo.it
Keys lock
This feature allows the user to lock the keypad to prevent accidental changes. All buttons on the remote
control are locked. To activate the key lock function, press [Prog] for 3 seconds. To deactivate the
function, repeat the procedure.
Open window Function
The device allows to detect the presence of an open window to limit the energy consumption, to activate this
mode, activate the Stand-by mode, press the [Chrono] key for more than 3 seconds, scroll the modes with
the key [+] and select FUNC with the [Prog] key, the window icon will flash in the upper left of the display,
using the [+] key select ON / OFF, visible in the center of the display, and confirm with [Prog] .
the
icon will be active during the thermostat operation, if the open window is detected, the icon will be
flashing and the system will turn off the heating for a maximum of 30 minutes or until a temperature increase
of at least 1, 5 ° C.
ASC Function
This function allows you to optimize the operating times of the device, in order to limit consumption, by
activating this mode the device will record the time necessary to bring a specific room to the set temperature,
adjusting its operation automatically, in this way thermostat can be activated after time setted if is possible to
reach the desired temperature in less time than that foreseen by the operating time intervals that have been
set. activate Stand-by mode, press the [Chrono] key for more than 3 seconds, scroll through the modes
with
the [+] key and select FUNC with the [Prog] key, press it until the icon appears on the upper part of
the screen, select ON with the [+] key and press [Prog] again to confirm. After a few seconds, the remote
control automatically returns to Stand-By mode.
ECO MODE
This mode reduces the consumption of electricity at 3 ° C (Comfort - 3 ° C). in Stand-by mode, press the
[Chrono] key for more than 3 seconds, scroll the voices with the [+] key and select FUNC with the
[Prog] key, press it until the ECO icon appears, select ON with the button [+] and press [Prog] again to
confirm. After a few seconds, the remote control automatically returns to Stand-By mode.
To Next Page
Loading...