Selmo Dynamic - Comfort and Night Modes; Operative Mode Selection

Selmo
Comfort technology
division
“Dynamic”
Electronic control for towel heaters
Rev. Beta
-
March 2018
Selmo
Electronic
Via Pacinotti, 24 - 35030 Rubano (PD) Italy- Tel 049.8976761, Fax 049.8976085 - www.selmo.it
EN
2.
COMFORT / NIGHT MODE
Two different temperature levels can be set:
-
"COMFORT" TEMPERATURE: this is the temperature used for the "Chrono", "Fil-Pilote" and
"Comfort" modes.
-
"NIGHT" TEMPERATURE: this is the temperature used for "Night" and "Chrono" modes.
The desired temperature setting can be set by pressing the [+] and [-] buttons.
The temperature regulation range is between 7 ° C and 32 ° C.
IMPORTANT!
The "Night" temperature is always lower than the "Comfort" temperature and the priority is
assigned to the "Comfort" temperature. For this reason the "Night" temperature can be set in the
range 7 ° C ÷ ("Comfort" - 0.5 ° C), on the contrary the "Comfort" temperature can be set within the
entire range: ("Night" + 0 , 5 ° C) to 32 ° C.
3.
OPERATIVE MODE
Press [Prog] to select the desired mode (see the picture).
On/Stand-By Crono Antifreeze Night Comfort Fil - Pilote
COMFORT MODE
The "Comfort" mode allows you to maintain the set room temperature.
To set this mode:
-
Press the [Prog] key until the "Comfort" mode icon appears on the display.
-
Set the desired temperature with the [+] and [-] buttons.
NIGHT MODE
In "Night" mode, a temperature lower than the "Comfort" temperature is set.
We recommend using this mode at night or when the room is not used for 2 hours or more.
-
Press the [Prog] key until the "Night" icon appears on the display.
-
Set the desired temperature with the [+] and [-] buttons.
ANTIFREEZE MODE
In the "Antifreeze" mode the temperature is set at 7 ° C. The appliance activates the heating element
when the room temperature drops below 7 ° C. We recommend using this mode when the room is not
used for several days.
-
Press the [Prog] key until the "Antifreeze" icon appears on the display.
TIMER 2H MODE
The "2h Timer" mode can be used to quickly heat the room or speed up the drying of the wipes.
-
Press the [Prog] key until the "" " icon appears on the display.
The appliance is switched on at maximum power for 2 hours, but the ambient temperature, for safety
reasons, cant be higher than 32°C. The "2h Timer" mode automatically stops after a period of 2 hours
and return to the previously set operating mode. If necessary, the user can return to other modes at
any time by simply pressing the [Prog] key.