Selmo Dynamic - Assembly With On-Board Elements

Selmo
Comfort technology
division
“Dynamic”
Electronic control for towel heaters
Rev. Beta
-
March 2018
Selmo
Electronic
Via Pacinotti, 24 - 35030 Rubano (PD) Italy- Tel 049.8976761, Fax 049.8976085 - www.selmo.it
EN
Assembly
(For on-board heating element versions)
1- For versions with
resistance on board, only
the thermostat must be
installed.
3- Fasten the heating
element to the body of
the towel heater using
a 22 mm wrench.
2- Insert the heating
element into one of the
two lower holes of the
heated towel rail.
4-
After fixing, make sure
that the thermostat
rotation range is sufficient
to satisfy the final
positioning needs.