“Dynamic”
Electronic control for towel heaters
Electronic
Via Pacinotti, 24 - 35030 Rubano (PD) Italy- Tel 049.8976761, Fax 049.8976085 - www.selmo.it
Assembly
(For on-board heating element versions)
5-
Once assembled and
verified the circular
movement excursion, it will
be necessary to mount the
plastic protections for the
resistance base.
7- The front part must be
lodged in its seat exerting a
pressure in the middle of it.
6-
Insert the front part first,
with protruding and
perforated flaps
8- Position the rear part
with the same procedure,
making sure that it is
securely hooked to the
chrono thermostat body.
8-Final result
The manufacturer reserves the right to make
any changes at any time he deems necessary
to improve the product without prior notice.
DISPOSAL
This appliance is not an ordinary waste. It must be
disposed of through appropriate collection
centers. In case of replacement, it can be return to
the distributor. This end-of-life treatment of the
product will allow us to preserve our environment
and to curb the consumption of natural resources.
This symbol applied to the product indicates the
obligation to deliver it to the appropriate collection
centers to be disposed of in compliance with the
directive 2002/96 / CE (WEEE).
To Previous Page
Loading...