Seltron RCD1 - Page 19

| 19Instructions for use
EN
S1 PARAMETER GROUP - SERVICE PARAMETERS
ADDITIONAL AND
SERVICE SETTINGS
No. Description Range
S1.2
ROOM TEMPERATURE
This setting determines which sensor is used for room
temp.
Info: For setting 3, median value of the installed and
auxiliary sensor is calculated for room temp.
0 - none
1 - built-in sensor
2 - auxiliary sensor
(AUX)
3 - built-in and addi-
tional sensor
S1.3
CALIBRATION OF BUILT-IN TEMPERATURE SENSOR
This setting determines the correction of measured
temp. of the built-in sensor.
-5,0 ÷ 5,0 °C (0,0)
S1.4
AUXILIARY TEMP. SENSOR (AUX) CALIBRATION
This setting determines the correction of measured
temp. of the auxiliary sensor.
-5,0 ÷ 5,0 °C (0,0)
S1.5
RELATIVE HUMIDITY SENSOR CALIBRATION
This setting determines the correction of measured
relative humidity in the room.
-10 ÷ 10 % (0)
S1.6
AIR PRESSURE SENSOR CALIBRATION
This setting determines correction of measured air
pressure.
-100 ÷ 100 mb (0)
S1.7
AIR QUALITY SENSOR CALIBRATION
This setting determines the correction of measured air
quality.
-1000 ÷ 1000 (0)
S1.8
LIGHT SENSOR CALIBRATION
This setting determines the correction of measured
lighting in the room.
0,5÷ 2 (1)
S1.9
LOCKING THE MENU
This setting limits access to parameter groups in the
menu.
0 - no lock
1 - S1
2 - P1, P2 and S1
S1.10
LOCKING BUTTONS
This setting locks button functionality.
Operation of locking buttons function is described in
the chapter »Locking butons«.
0 - no lock
1 - operation type,
2 - same as 1 and
functions,
3 - same as 2 and desi-
red temp.,
4 - same as 3 and info
browsing and settings.
S1.11
MINIMUM SETTING OF REQUESTED TEMP.
This setting determines minimum possible setting of
room temp.
4 ÷ 40 °C (6)