2. Press “CF” key, then press this key to turn on/off the MG function
3. Press “MG” key for 3 seconds to set the MG sensitivity level, “1 “is the lowest, “9” is
the highest, “0” is off
4. Operation
User can select the function according to their needs when count the notes
1）Turn on/off the machine
By pressing the power switch
NOTES：Turn on the machine, both count display and batch/check display will show the software version
(eg. *0106) firstly, then show the model number (eg. 900), at last show all “8” after self-detection. In the
process of self-detection, if the machine has sensor fault, it will display the error code in the count
display.(details in the Error messages and solutions)
To Next Page
Loading...