Sena NS10 - Advanced Configuration Options; Multipoint Pairing Configuration; Phone Selective Pairing Configuration; Media Selective Pairing Configuration

| NS10
4
To go into mobile phone pairing mode, tap the (+) Button or the (-) Button until you hear a voice prompt, “Phone pairing”.
Please refer to section 7.1 for details on mobile phone pairing. If you tap the (+) or (-) Button, you can exit from the phone
pairing mode.
3.2 Multipoint Pairing
Voice Prompt
“Multipoint pairing”
Factory Default N/A
To go into multipoint pairing mode, tap the (+) Button or the (-) Button until you hear a voice prompt, “Multipoint pairing”.
Please refer to section 7.2 for details on multipoint pairing. If you tap the (+) or (-) Button, you can exit from the multipoint
pairing mode.
3.3 Phone Selective Pairing
Voice Prompt
“Phone selective pairing”
Factory Default N/A
To go into phone selective pairing mode, tap the (+) Button or the (-) Button until you hear a voice prompt, “Phone
selective pairing”. Please refer to section 8 for more details on phone selective pairing. If you tap the (+) or (-) Button,
you can exit from the phone selective pairing mode.
3.4 Media Selective Pairing
Voice Prompt
“Media selective pairing”
Factory Default N/A
To go into media selective pairing mode, tap the (+) Button or the (-) Button until you hear a voice prompt, “Media
selective pairing”. Please refer to section 8 for more details on media selective pairing. If you tap the (+) or (-) Button,
you can exit from the media selective pairing mode.
3.5 Enabling/Disabling Voice Activated Phone Answering
Voice Prompt
“VOX phone”
Factory Default Enable