| NS10
7
Multipoint Pairing None
Phone Selective Pairing None
Media Selective Pairing None
VOX Phone Enable / disable
VOX Intercom Enable / disable
VOX Sensitivity
- Set up 1 /2 / 3 / 4 / 5 or
cancel
- Enter adjustment
mode
- Save and exit
Voice prompt Enable / disable
Delete All Pairings Execute
Factory Reset Execute
Exit Configuration Execute
Voice Configuration Menu & Button Operations
4. PAIRING THE NS10 WITH BLUETOOTH DEVICES
Before using the NS10 Bluetooth headset with any of Bluetooth devices for the first time, you need to do the pairing
operation. It can be paired with Bluetooth mobile phones, Bluetooth stereo devices such as MP3, or motorcycle specific
Bluetooth GPS, and with Bluetooth adapter or transmitter such as Sena SR10 or SM10. This pairing operation is only
required once for each Bluetooth device. The headset will remain paired with the devices and automatically connects to
the paired devices again when they are within range. You will hear a high tone single beep and a voice prompt when the
headset connects to the paired device automatically: “Phone connected” to a mobile phone, “Media connected” to a
Bluetooth stereo device.
4.1 Mobile Phone Pairing
1. To enter into the voice configuration menu, press and hold the Center Button for 10 seconds until you hear a voice
prompt, “Configuration menu”.
2. By tapping the (+) Button, you will hear a voice prompt, “Phone pairing”.
3. Search for Bluetooth device on your mobile phone. Select the SenaNS10 in the list of the devices detected on the
mobile phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for the PIN.
5. The mobile phone confirms that pairing has completed and the NS10 is ready to use. You will hear a voice prompt,
“Your headset is paired”.
6. If the pairing process is not completed within three minutes, the NS10 will return to stand-by mode.
To Next Page
Loading...
Need help?
General
