| NS10
9
If you use GPS only for turn-by-turn voice instructions, not for Bluetooth stereo music streaming, multipoint pairing is
recommended for the GPS connection. Multipoint Bluetooth pairing allows the NS10 to connect two HFP devices at the
same time: mobile phone and GPS navigation. Follow the steps below to pair the GPS using the multipoint pairing.
1. To enter into the voice configuration menu, press and hold the Center Button for 10 seconds until you hear a voice
prompt, “Configuration menu”.
2. Tap the (+) Button and you will hear a voice prompt, “Phone pairing”.
3. Search for Bluetooth devices on the GPS navigation screen. Select the SenaNS10 in the list of the devices detected
on the GPS.
4. Enter 0000 for the PIN.
5. The GPS confirms that pairing has completed and the NS10 is ready to use. You will hear a voice prompt, “Your
headset is paired”.
6. If the pairing process is not completed within three minutes, the NS10 will return to stand-by mode.
4.4.2 GPS Pairing as Mobile Phone
If GPS is not only used for turn-by-turn voice instructions but also is your preferred Bluetooth stereo music source, you
can pair the GPS to the NS10 by following the simple procedures in “7.1 Mobile Phone Pairing”. When you do this, the
NS10 thinks the GPS is a mobile phone. But NS10 can directly pair an additional mobile phone.
Note:
You have to use a motorcycle specific GPS which transmits turn-by-turn voice instruction to the headset by Bluetooth.
Most automotive GPS systems don’t have this feature.
4.5 Pairing with the Sena SR10, Bluetooth Two-way Radio Adapter
The Sena SR10 is a Bluetooth two-way radio adapter for group communication, and uses HFP as do most motorcycle
specific GPS navigation systems. If you pair the NS10 with a SR10 by multipoint pairing, the NS10 is able to have two
HFP devices at the same time: mobile phone and Sena SR10.
1. To enter into the voice configuration menu, press and hold the Center Button for 10 seconds until you hear a voice
prompt, “Configuration menu”.
2. Press the (+) Button twice and you will hear a voice prompt, “Multipoint pairing”.
3. Turn on the SR10 and follow the SR10’s “Bluetooth Headset Pairing” procedure to complete the process. Please
refer to the SR10 user's guide for details.
4. When the pairing is completed, you will hear a voice prompt, “Your headset is paired”.
5. If the pairing process is not completed within three minutes, the NS10 will return to stand-by mode.
The incoming audio from the two-way radio via SR10 is heard in the background while having an intercom conversation
or a mobile phone call. You can listen to music, answer a mobile call, have an intercom conversation and use a two-way
To Next Page
Loading...
Need help?
General
