9
4. Peel off the cover of the hook and loop
fastener for wired microphone to expose the
adhesive tape. Then, attach the hook and
loop fastener on the inside of the helmet’s
chin guard.
5. Attach the wired microphone to the hook
and loop fastener for wired microphone.
2.3.2 Wired Microphone Type
If you have a full face helmet, you can use the wired
microphone.
1. Remove the cover of the adhesive sticker of
the hook and loop fasteners for speakers.
2. Place the sticker on the helmet.
3. Place the speaker on the hook and loop
fasteners.
To Next Page
