Sena SMH5 - 10.6 Exit Voice Configuration Menu; 11. USING THE SMH5; 11.1 Volume Adjustment; 11.2 Mobile Phone Call Making and Answering

SMH5
20
10.6 ExitVoiceCongurationMenu
Voice Prompt
“Exit conguration”
Factory Default N/A
Enable Tap the Phone Button
To exit voice conguration menu and get back to stand-by mode,
rotate the Jog Dial until you hear a voice prompt saying “Exit
conguration
”, and tap the Phone Button to conrm. Tapping the
Jog Dial is not available for this setting.
Rotate Jog Dial Tap Phone Button Tap Jog Dial
Speed Dial Execute N/A
VOX Phone Enable Disable
Voice Prompt Enable Disable
Sidetone Enable Disable
Delete All Pairings Execute N/A
ExitConguration Execute N/A
Voice Conguration Menu & Button Operations
11. USING THE SMH5
11.1 Volume Adjustment
You can easily adjust the volume by rotating the Jog Dial. You will
hear a beep when the volume reaches maximum or minimum level.
The volume is set and maintained independently at different levels for
each audio source even when you turn off and on the headset. For
example, once you set the volume for mobile phone handsfree, it will
not change even if you adjust the volume when you hear Bluetooth
MP3 music. So you can always maintain the preferred optimum
volume level for each audio source.
11.2 Mobile Phone Call Making and Answering
1. When you have an incoming call, simply tap the Jog Dial or the
Phone Button to answer the call.
2. You can also answer the incoming call by loudly speaking any
word of your choice if Voice Activated Phone Answering is enabled.
(Refer to the next section for details.)
3. To end a call, tap the Jog Dial or the Phone Button, or wait for the
called person to end the call.
4. To reject a call, press the Jog Dial for 2 seconds until you hear a
beep while the phone is ringing.