What to do if Senco FINISHPRO 18 Nail Gun is jamming?
If your Senco Nail Gun is experiencing poor feed or jamming, try cleaning the tool or lubricating the magazine. If the issue persists, consider installing Parts Kit D.
What to do if Senco Nail Gun has air leak near bottom?
If you notice an air leak near the bottom of your Senco Nail Gun or experience poor return, clean the tool and tighten the screws. If the issue continues, consider installing Parts Kit B.
What to do if my Senco FINISHPRO 18 Nail Gun has an air leak near the top or is operating sluggishly?
If your Senco Nail Gun has an air leak near the top or is operating sluggishly, verify the air supply and tighten the screws. Alternatively, install Parts Kit A.
What to do if my Senco FINISHPRO 18 has an air leak near the bottom or has poor return?
If your Senco Nail Gun has an air leak near the bottom or experiences poor return, clean the tool and tighten the screws. Another option is to install Parts Kit A.
What to do if Senco FINISHPRO 18 Nail Gun has air leak near top / sluggish operation?
If your Senco Nail Gun has an air leak near the top or is operating sluggishly, verify the air supply. You may also need to tighten the screws or install a Parts Kit.
What to do if Senco FINISHPRO 18 Nail Gun has air leak near bottom / poor return?
If your Senco Nail Gun has an air leak near the bottom or poor return, clean the tool and tighten the screws. You might also need to install a Parts Kit.
Details employer's duty to ensure tool users read and understand the manual.
Explains the basic function and components of the power fastener driving tool.
Instructions for operating the FinishPro 2N1 model.
Instructions for operating the FinishPro 10 and LS1XP models.
Specific operating instructions for the FinishPro 10 model.
Operating instructions for FinishPro 2N1, 15, and 18 models.
Important safety precautions before performing maintenance.
Daily checks and cleaning procedures for tool upkeep.
Identifies common issues and provides corrective actions for tool problems.
Lists the range of available accessories for SENCO tools.
Detailed technical data for each tool model.
Specifications for fasteners used with FinishPro 2N1 and 10 models.
Specifications for fasteners used with FinishPro 15/18 and LS1XP models.
Details on noise levels generated by the tools.
Details on vibration levels generated by the tools.
Formal statement confirming product compliance with directives and standards.
Specifies the warranty duration for different SENCO product lines.
Outlines the process for submitting warranty claims and exclusions.
General| Gauge | 18 |
|---|---|
| Fastener Range | 5/8" - 2" |
| Magazine Capacity | 110 |
| Operating Pressure | 70 - 120 PSI |
| Air Inlet | 1/4" NPT |
| Fastener Type | Brad Nails |
| Power Source | Pneumatic |
| Depth Adjustment | Yes |
| Tool-Free Jam Release | Yes |
To Next Page