Need help?Do you have a question about the Senco FinishPro 35 and is the answer not in the manual?
Describes how to use the 'Contact Actuation' trigger for driving nails.
Steps to disconnect air supply and empty the magazine before maintenance.
Emphasizes keeping screws tight and daily inspection of safety yoke and trigger.
States routine lubrication is not necessary; instructions for air inlet lubrication.
Addresses air leaks, sluggish operation, and poor return issues.
Covers issues with the driver, weak drive, poor feed, or jamming.
For addressing any problems not specifically listed.
Lists codes and dimensions for nails compatible with specific models.
Lists codes and dimensions for nails compatible with the FinishPro™ 32 model.
Presents noise level data according to EN 792-13 standard.
Presents vibration level data according to EN 292 Part 1 & 2.
To Next Page
General