EasyManua.ls Logo

Sencor SHB 31GR - Before First Use; Attaching and Removing the Blending Attachment; Using the Appliance; Advice and Tips for Blending

Sencor SHB 31GR
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN-6
07/2014
Copyright © 2014, Fast ČR, a.s.
Hand Blender
SHB 30WH / SHB 31GR / SHB 32BL / SHB 33OR / SHB 34RD / SHB 35VT / SHB 36YL / SHB 37GG / SHB 38RS
EN
BEFORE FIRST USE
1. Take the appliance and its accessories out of the packaging materials.
2. Thoroughly wash the removable blending attachment A4 and the beaker A6 with hot water and
kitchen washing detergent. Thoroughly rinse these parts with drinking water and dry thoroughly.
Attention:
Make sure that no water remains in the blending attachment A4, which could enter into the
motor unit A3 when the appliance is assembled and cause damage to it.
ATTACHING AND REMOVING THE BLENDING ATTACHMENT
1. Place the blending attachment A4 against the motor unit A3 and attach it by turning it in the
direction of the closed padlock symbol marked on the appliance.
2. To disassemble the blender, use one hand to hold the motor unit A3 and the other to turn the
blending attachment A4 in the direction of the open padlock symbol marked on the appliance
and take it off.
USING THE APPLIANCE
1. This blender is designed for blending spreads, mayonnaises, fruit- or milkshakes, sauces, baby food,
purée, etc.
2. Place the ingredients that you wish to blend into the beaker A6 or another suitable container.
3. Connect the power cord to an el. power socket. Hold the blender by the motor unit A3 and
submerge the blending attachment A4 into the container with the ingredients.
4. To turn on the blender, press switch A2. The blender will run while switch A2 is pressed. For safety
reasons the blender will turn off when switch A2 is released.
Attention:
The maximum operating time of the blender is 1 minute. After one minute, interrupt the
operation of the appliance for at least 2 minutes.
If you are using the blender to blend sticky or hard food, reduce the operating time to 20
seconds.
5. Control dial A1 is used to variably control the motor speed.
6. If you will not be using the blender, disconnect it from the power socket.
ADVICE AND TIPS FOR BLENDING
1. Cut food into smaller pieces before blending it. Separate larger amounts of food into several
smaller batches.
2. The volume of some liquids increases when they are blended and for this reason only fill the beaker
A6 to ¾ of its capacity. The maximum capacity of the beaker is indicated by the 500 ml mark.
Attention:
Do not use the blender for mixing ice cubes or coffee beans. Otherwise the mixing blades A5
could be damaged.

Related product manuals