Sencor STM 3010WH - Page 4

Food Mixer
STM 3010WH / STM 3011GR/ STM 3012BL/ STM 30130R
STM 3014RD / STM 3015VT / STM 3016YL/ STM 3017TQ / STM 3018RS
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY AND STORE FOR FUTURE USE.
Before connecting this appliance to a power socket, make sure the voltage stated on the rating
label of the product corresponds to the voltage in your power socket.
Never use accessories, which have not been supplied with this appliance or which have not been
explicitly recommended by the manufacturer.
The appliance is intended and designed for processing a standard amount of food in the household.
Do not use the appliance for anything other than its intended purpose.
Do not use the appliance in an industrial environment or outdoors.
Do not use sprays in the vicinity of the appliance.
Do not place the appliance on window sills or on unstable surfaces. Only place the appliance on an
even, dry and stable surface.
Do not place the appliance on an electric or gas stove, in the vicinity of an open flame or appliances
that are sources of heat.
Ensure that the power plug contacts do not come into contact with water or moisture.
Do not wash the appliance (except for the removable attachments and mixing bowl) under running
water and do not submerge it in water or any other liquid.
Before attaching attachments to the appliance, removing or replacing them, ensure that the
appliance is turned off and disconnected from the power socket.
For safety reasons, this appliance is equipped with a safety mechanism that prevents the motor
from being started if the appliance's arm is tilted out.
Before putting the appliance into operation, check that it is correctly assembled and that the arm
is in the horizontal position.
Allow hot liquids or food to cool down before mixing them.
Do not leave the appliance in continuous operation under a heavy load for a period longer than 6
minutes. Before turning it on again, allow it to cool down for at least 10 minutes.
Do not tilt out the arm or put your hands or items, such as a kitchen knife, fork or wooden spoon,
into the bowl while mixing. Do not touch the rotating attachments and ensure that foreign items
such as clothing, hair, etc. are kept away. An injury could occur or the appliance could be damaged.
If an item, such as a spoon, falls into the mixing bowl while the appliance is running, immediately
set the speed control knob to position 0 (stand-by mode), disconnect the power cord from the
power socket and take the item out of the bowl.
If ingredients stick to the attachments or the inside of the bowl, turn off the appliance and
disconnect it from the power socket. Use a spatula to clean the attachments and the inside of the
bowl. Then you can continue mixing.
Do not turn the appliance on when empty. The incorrect use of the appliance may negatively affect
its lifetime.
Always turn off the appliance and disconnect it from the power socket if you will not be using it and
if you will be leaving it without supervision, before assembly, disassembly, cleaning or moving it.
Before storing the appliance, check that the stand arm is tilted to the horizontal position.
Do not place heavy items on the power cord. Make sure the power cord does not hang over the
edge of a table, or that it does not touch a hot surface.
Do not disconnect the appliance from the power socket by pulling on the power cord. This could
damage the power cord or the power socket. Disconnect the cord from the power socket by gently
pulling the plug of the power cord.
If the power cord is damaged, have it replaced at a expert service centre. It is forbidden to use the
appliance if it has a damaged power cord or plug.
To avoid the danger of injury by electrical shock, do not repair the appliance yourself or make any
adjustments to it. Have all repairs or adjustments of the appliance performed at an authorised
service centre. Tampering with the appliance during the warranty period may void the warranty
policy.
Copyright © 2013, Fast CR, a.s. Revision 10/2013