Sendai CD789 - Menu Function; Traffic and Radio Settings; Audio and System Settings

7
TA VOL:
Rotate the knob to adjust TA volume.
RETUNE mode:
Rotate the knob to choose RETUNE-S or
RETUNE-L.
RETUNE-S or RETUNE-L is time length
selection of TA SEEK retune interval.
RETUNE-S: Short, TA SEEK retune
interval is 45 seconds.
RETUN E - L: Long, TA SEEK r etune
interval is 180 seconds.
Remark: RETUNE mode functions for TA
during TA SEEK mode only.
DSP mode:
Rotate the knob to choose DSP sound effect:
POP->ROCK->CLASSIC->FLAT-> DSP OFF
EPS mode:
ESP 12s: Se l ec te d a s C D- E S P t i m e 1 2
sec onds, MP3-ESP time >100
seconds.
ESP 45s: Se l ec te d a s C D- E S P t i m e 4 5
sec onds, MP3-ESP time >100
seconds.
MULT ON/OFF:
Multi Session ON/OFF. (Multi session OFF:
mixed CD, ONE session CD; Multi session
ON: Mixed, Extra, multi session CD)
LOUD ON/OFF :
Rotate the knob to select loudness on or off.
BEEP ON/OFF:
Rotate the knob to choose beep sound on or
off.
SEEK 1/2 mode:
Rotate the knob to choose radio seek
mode 1 or 2 .
SEEK 1: Searching station will stop when
next station is received.
SEEK 2: Searching station will stop when
or button is released and next
station is received.
STEREO/MONO mode:
Rotate the knob to select FM stereo/mono
mode.
LOCAL/DX mode:
Rotate the knob to select radio local/distant
mode.
VOL mode:
VOL LAST: the turn-on volume level is the
volume level of latest power off.
VOL ADJ: At volume adjust mode, press
the knob to enter A-VOL mode, then rotate
the knob to set the turn-on volume level.
Menu Function
Press the knob more than 2 seconds to enter
menu mode , then each press changes the
mode as follows:
TA mode -> MASK mode -> TA VOL ->
RETUNE mode -> DSP mode -> ESP mode
-> MULT ON/OFF -> LOUD ON/OFF -> BEEP
ON/OFF -> SEEK1/2 mode (only in tuner
mode) -> STEREO / MONO mode -> LOCAL /
DX mode -> VOL mode
TA mode:
Rotate the knob to choose TA ALARM or
TA SEEK mode, When TA is turned on
and no traffic program identification code
has been received during the specified
time, no TA/TP is displayed and according
to the MENU SELECT, alarm is set off, or
TA SEEK is activated.
TA ALARM mode: NO TA/TP is displayed
and alarm is set off.
TA SEEK mode: TA SEEK is activated.
MASK mode:
Rotate the knob to choose MASK DPI or
MASK ALL mode.
MASK DPI mode: Only the AF which has
differentprogramidenticationismasked.
MASK ALL mode:
The AF which has different program
identicationandNORDSsignalwithhigh
eldstrengthismasked.