IoT into the Wild
31
2) Select the Frequency Plan, if the gateway is US915, set the sensor to US915.
3) Click the “Send” button, send the setting to the sensor for it to take effect.
4) Click the “Home” button, the App will disconnect the Bluetooth connection.
Then, the sensor will reboot.
5) When the device is disconnected from Bluetooth, the LED lights up for 5 seconds and
then flashes as a breathing light.
6) After joining the network successfully, LED flashes fast for 2s.
6.3.6 Check Data on SenseCAP Portal
Please refer to the section 6.2.6
To Next Page
Loading...
