Sensitech TempTale RF - Section 1: Hardware Configuration Instructions for TTRF Infrastructure; Equipment; Configuring the TTRF Gateway for a Static IP Address or DHCP Agent

Hardware Configuration Instructions
for TTRF Infrastructure
 SENSITECH INC
REV A 9/6/2005
4
Section 1: Hardware Configuration Instructions for TTRF Infrastructure
These instructions guide a technician through the installation and configuration of the TempTale
RF infrastructure.
Equipment
 RS232 Serial cable (1)
 TTL Converter (1)
 RJ45 Ethernet crossover-cable (1)
 TTRF Gateway (1)
 Repeater (1)
 Gateway Power Adaptor (1)
 Repeater Power Adaptor (1)
 PC with Start Hyper Terminal installed
 PC with scientific calculator
 Ethernet connection
Configuring the TTRF Gateway for a static IP address or DHCP agent
Gateway
2
1) Make sure power is off on the TTRF Gateway.
2
Repeater/Signposts use the same Motherboard.