SolaStat™-1-3 Installation Guide
Version 1.1 – April 2013 Page 12
POWERING UP, CONTINUED
Final Checks
The SolaStat
TM
is now fully installed and should be working.
It is best to observe some solar hot water pump cycles, but this will depend
on the sun shining.
Check all functions are working correctly before leaving the installation.
The SolaStat™ settings have been factory set to the standard settings for
your area and requirements.
These can be adjusted by a qualified installer, using the instructions in the
‘Programming the SolaStat™’ section on pages 18-25 in this manual.
See ‘Trouble Shooting’ section on page 28 of this guide if the system is not
working correctly.
To Next Page
Loading...
