29
AMPS Ratchet Hinge Mount
The optional Ratchet Hinge Mount secures the SCC3 to the vehicles
interior and provides viewing angle adjustment in the vertical plane.
1. Fit one half of the AMPS bracket to the AMPS backplate on the rear
of the SCC3, using the screws and washers provided. Fit the optional
p-clip to one of the mounting points, routing any cables through from
the SCC3.
MAX 0.8 Nm
Do not over tighten
PZ-1
2. Fit the other half of the bracket into position using four screws.
3. Fit the two brackets together using the screw and nut provided. Before
fully tightening, adjust the SCC3 to the desired angle.
CAUTION! Allow sucient slack in the cables for
hinge adjustments.
CAUTION! Ensure xing screws are of an appropriate
type and length for the surface material the bracket is
being mounted on to.
To Next Page
Loading...