30
AMPS Ball Mount
The optional ball mount provides exible mounting options for the SCC3
when used in conjunction with the range of compatible mounting arms
and brackets.
1. Fit the AMPS ball mount to the AMPS backplate on the rear of the
SCC3 using suitable screws and washers. Fit the optional p-clip
to one of the mounting points, routing any cables through from the
SCC3.
MAX 0.8 Nm
Do not over tighten
PZ-1
2. Fit a compatible mounting kit to the ball mount, such as a double
socket arm. Ensure any mounting components are fully tightened after
adjustments.
Handset-Based Console (HBC3)
The HBC3 is supplied with a magnetic mounting bracket and interface
box. The bracket can be mounted separately or on the box.
CAUTION! The interface box is not sealed. Avoid
positions with risk of exposure to water or dust entry.
1. Open the interface box by removing the
three screws from the cover of the box.
2. Connect the transceiver to the 16-way header in the interface box
using a Remote Console cable. Ensure that the strain relief bung is
seated at the cable entry in the box front with the at face down.
CAUTION! ESD precautions must be taken during
replacement of the rear cover.
To Next Page
Loading...