Sepura SCG22 Series - Installation Precautions and Antenna Safety; Internal Back-up Battery; Certified Antennas and RF Safety

3
WARNING! DO NOT smoke or use naked ames when
working near the vehicle’s fuel system.
READ ALL THE INSTRUCTIONS before attempting to install the SCG22.
If you do not understand the instructions, STOP and contact your service
provider or Sepura for assistance.
Always read the vehicle manufacturer’s handbook before starting to install the
product. Installation of this product may a󰀨ect the vehicle electrical systems.
CAUTION! Prolonged operation of the SCG22 with the
vehicle engine powered OFF, may drain the vehicle’s
battery.
Disconnect the vehicle’s battery before commencing
installation (be aware of the e󰀨ect on the public broadcast
radio security code, alarm systems and some engine
management systems).
Ensure that fuel lines, hydraulic lines and existing cables are not damaged
during installation.
Ensure that the installation does not impede the normal operation of the
vehicle, including the operation of any safety device, e.g., airbags and seatbelt
tensioners.
Speed control, fuel injection, anti-lock braking, navigation, air bag and other
electronic systems are relatively immune to RF interference. However, if
di󰀩culty is experienced or faulty operation is suspected, consult the vehicle’s
dealer.
ALWAYS perform RF compatibility checks after installation. See "RF
Compatibility Checks" on page 6.
Certied Antennas
The SCG2229 is certied for use with a 2 dBi gain Bluetooth / Wi-Fi antenna
and a 7 dBi TETRA antenna. Higher gain antennas should not be used to
ensure compliance with RF eld strength limits. Minimum distances from
antenna to users are given in the following table:
CAUTION! Only use hand tools and do not over-tighten
screws and xings.
CAUTION! Risk of product damage. When carrying out
installation requiring the removal of product covers, ESD
precautions must be taken.
Installation Precautions
The SCG22 mobile radio has a small rechargeable internal back-up battery.
This battery powers the internal Real Time Clock in the event that the main
power to the product is removed.
The battery may have discharged during the manufacturing process or if the
product has been in storage for some time.
When the product is connected to its main supply, the back-up battery will
charge regardless of whether the product is powered on or not. The period for
a full charge may be up to 48 hours.
CAUTION! The SGC22 contains a backup battery. The
battery must not be replaced by the user. The equipment
must be disposed of using correct WEEE requirements.
The equipment must not be dismantled, or left in conditions
outside of the stated environmental storage and operating
specications.
WARNING! This equipment is not suitable for use in
locations where children are likely to be present.
Mobile Radio Internal Back-up Battery
Contact the vehicle manufacturer if you are not certain if it is safe to install this
product.
Region
Occupational
Minimum Distance
General Public
Minimum Distance
Canada 0.4 m 1.2 m
USA 1 m 1 m
EU / UK 0.5 m 1 m