Sepura SCG22 Series - SCC3 DIN Mount Kit Installation

24
SCC3 Mounting Options
There are a number of options available for mounting the SCC3 console
within the vehicle, including direct mounting onto the front panel of the
SCG22 (see "Front Mounting the SCC3 Console" on page 10). This
guide provides information on installing the SCC3 using the AMPS or DIN
slot mount kits designed for in-vehicle use. Choose the best mounting
option to suit the vehicle.
Note: For installations in marine environments,
contact Sepura for available IP67 mounting options.
Dash Mounted Pivot Kit
CAUTION! The dash mount bracket must be xed to
a suitable and stable surface capable of bearing the
weight of the SCC3.
The SCC3 is mounted into the desired position utilising the console dash
mounted pivot kit. This kit consists of a dash mount bracket onto which
the pivot support bracket is attached.
The SCC3 is then attached to the pivot support bracket.
Ensure orientation is correct for the viewing situation (tilt up or tilt down)
and access is considered to the RS232 data connector, if required.
198
25
Extent of the SCC3 profile when orientated
parallel to the mounting surface
All dimensions are in millimetres
Position of data connector - Allow for
access to the connector if required
56
36.5 36.5
58
72
24
17
77
12
99
Extent of the SCC3 profile when
orientated at 90° to the mounting surface
Drill three holes at the fixing centres indicated
to suit the fastener type (4.2 mm self-tapping
screws supplied with the pivot mount kit)
45
Fixing Hole Positions
Note: The SCC3 prole includes a small clearance
allowance. Additional allowances should be made for
cables depending on the installation conguration.