25
1. Secure the dash mount bracket
into position using the three
self-tapping screws provided.
2. Make the cable connections to the SCC3. See the section "Cabling
the SCC3" on page 23.
3. Fix the Pivot mount support bracket to the rear of the SCC3 using the
two screws provided (maximum tightening torque = 0.8 Nm). Ensure
that all cables are routed correctly and will not become trapped when
the backplate is tted.
MAX 0.8 Nm
Do not over tighten
4. Slot the pivot mount support bracket into the dash mount bracket.
Secure in place using the single xed sprung screw knob.
The viewing angle of the SCC3 can be adjusted by loosening the release
knob until the tilt mechanism is free enough to move. A ratchet action
provides incremental positioning. The release knob should then be re-
tightened to x the SCC3 into position.
PH2
To Next Page
Loading...