31
3. Press the inner wires of the Remote Console cable into the clips on
the PCB.
CAUTION! Take care not to damage ne wiring or
trap any cables.
5. Screw the box halves back together securely, ensuring any cables are
tted correctly through the cable entry points.
4. Connect the optional remote microphone and switches cable into the
10-way connector. Route the cables neatly through the cable entry
points.
Note: Before tting the optional remote microphone
and switches cable see the section "Remote
Microphone and Switches Installation" on page 32.
6. Plug the HBC3 into the interface box through the retaining clip and
fold the clip back over the connector body to retain it securely in
position.
7. Fit the mounting bracket to the vehicle dash in a suitable location or
directly to the interface box. Place the handset in the mounting bracket
with the display facing the user.
To Next Page
Loading...