6
Installation, Operation and Care:
PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE
GENERAL
SERV-WARE ranges are produced with quality workmanship and material. Proper
installation, usage and maintenance of your range will result in many years of
satisfactory performance.
SERV-WARE suggests that you thoroughly read this entire manual and carefully
follow all of the instructions provided.
THIS APPLIANCE IS EQUIPPED FOR NATURAL GAS,
for conversion to LP gas please see gas conversion
instruction manual attached. Orifices necessary for LP
(propane) (natural) conversion are provided. Please refer
to page 3 the orifice size list when you do gas conversion
INSTALLATION
UNCRATING
This range was inspected before leaving the factory. The transportation company
assumes full responsibility for safe delivery upon acceptance of the shipment.
Immediately after unpacking, check for possible shipping damage. If the range is
found to be damaged, save the packaging material and contact the carrier within 15
days of delivery.
Uncrate unit carefully and place in a work-accessible area as near to its final
installed position as possible. Remove all shipping wire and wood blocking.
Before installing, check the type of gas supply (natural or propane) to make sure
they agree with the specifications on the rating plate located on the inside of the
lower kick panel. If the supply and equipment requirements do not agree, do not
proceed with the installation. Contact your dealer or SERV-WARE Company
immediately.
LOCATION
The appliance must be installed under a ventilation hood.
The equipment area must be kept free and clear of combustible substances.
To Next Page
Loading...
