Server Technology PRO2 - Page 192

PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 192
Command Syntax
set dhcp [disabled | enabled]
set dhcp fqdn [disabled | enabled]
set dhcp fqdn name <name>
set dhcp staticfallback [disabled | enabled]
set dhcp bootdelay [disabled | enabled]
Parameters
The set dhcp command uses the following parameters:
Sub-Parameters
The set dhcp command uses the following sub-parameter:
Command Access
Command Syntax
set dns [primary | secondary] <ipv4/ipv6>
Parameters
Command Access