PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 193
Command Syntax
set email auth [disabled | enabled]
set email config [disabled | enabled]
set email [disabled | enabled]
set email event [disabled | enabled]
set email fromaddr <email addr>
set email power [disabled | enabled] See Note below.
set email smtp authtype [any | crammd5 | digestmd5 | login | plain | none]
set email smtp host <hostname>
set email sm
tp password <password>
set email sm
tp port <port>
set email smtp usefromaddr
set email smtp username <user name>
set email smtp useusername
set email test
set email toaddr1 <email addr>
set email toaddr2 <email addr>
set email trendfiles [disabled | enabled]
set email usesubjloc
set email usesubjdef
Note: The set email power command is for Switched products only.
Parameters
The set email command uses the following parameters:
To Next Page
Loading...