Server Technology PRO2 - Page 203

PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 203
Command Syntax
set location <location string>
Parameters
The set location command uses the following parameter:
Command Access
Command Syntax
set net [disabled | ipv4only | dualv6v4]
Parameters
The set net command uses the following parameters:
Command Access
Command Syntax
set ocp email [disabled | enabled] <name | id | ALL>
set ocp loadmax <name | id | ALL> <value>
set ocp snmpt [disabled | enabled] <name | id | ALL>
Parameters
The set ocp command uses the following parameters:
Command Access