Server Technology PRO2 - Page 202

PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 202
Command Syntax
set loadshed branch [disabled | enabled]
set loadshed line [disabled | enabled]
set loadshed sensor [disabled | enabled]
set loadshed sensor contact [recoveroff | recoveron] <contact sensor name | id | ALL>
set loadshed sensor temp [recoveroff | recoveron] <temp sensor name | id | ALL>
set loadshed sensor water [recoveroff | recoveron] <water sensor name | id | ALL>
set loadshed ups [all | any] <line name | id | ALL>
set loadshed ups [disabled | enabled]
set loadshed ups [recoveroff | recoveron]
set loadshed ups [recoverdelay | sheddelay] <delay>
Parameters
The set loadshed command uses the following parameters:
Sub-Parameters
The set loadshed command uses the following sub-parameters:
Usage Guidelines
The Smart Load Shedding feature must be enabled.
Command Access