Server Technology PRO2 - Page 213

PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 213
Command Syntax
set sntp dst [disabled | enabled]
set sntp dst [end | start] <tz string>
set sntp gmtoffset <offset>
set sntp primary <hostname>
set sntp secondary <hostname>
Parameters
The set sntp command uses the following parameters:
Sub-Parameters
The set sntp command uses the following sub-parameters:
Command Access
Command Syntax
set spm [disabled | enabled]
set spm resetpw
Parameters
The set spm command uses the following parameter:
Command Access