Server Technology PRO2 - Page 214

PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 214
Command Syntax
set ssh [disabled | enabled]
set ssh port
set ssh authmethod [all | kbint | password]
Parameters
The set ssh command uses the following parameters:
Sub-Parameters
The set ssh command uses the following sub-parameters:
Command Access
Command Syntax
set syslog debugmsg [disabled | enabled]
set syslog host1 <hostname>
set syslog host2 <hostname>
set syslog port <port>
set syslog protocol [rfc3164 | rfc5424]
Parameters
The set syslog command uses the following parameters:
Command Access