PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 220
set wlan
Description:
Sets the wireless network configuration.
Command Syntax:
set wlan [disabled | enabled]
set wlan bssid <ap bssid>
set wlan key <ap key>
set wlan mac <mac address>
set wlan security [open | wep-open | wep-shared | wpapsk-aes | wpapsk-tkip | wpapsk-tkipaes |
wpa2psk-aes | wpa2psk-tkip | wpa2psk-tkipaes]
set wlan ssid <ap ssid>
Command Access:
Admin level only; wireless module installed.
set ztp
Description:
Sets the Zero Touch Provisioning (ZTP) feature.
Command Syntax:
set ztp [autoupdate | disabled | enabled | resetprov]
set ztp autoupdate [day |disabled |enabled | hour]
set ztp resetprov
Parameters
The set ztp command uses the following parameters:
Sub-Parameters
The set ztp autoupdate command uses the following sub-parameters:
Command Access:
Admin level only
To Next Page
Loading...