Server Technology PRO2 - Page 230

PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 230
Command Syntax
show network
Command Access
Example
Switched PDU: show network
Network Configuration
State: Static IPv4 Network: IPv4 only
Link: Up Negotiation: Auto
Speed: 100 Mbps Duplex: Full
Ethernet MAC: 00-0A-9C-60-00-0A
AutoCfg IPv6: FE80::20A:9CFF:FE60:A/64
IPv4 Address: 10.1.2.205 Subnet Mask: 255.255.0.0
IPv4 Gateway: 10.1.1.1
DNS1: 10.1.5.133
DNS2: 10.1.5.134
Static IPv4/IPv6 Settings
IPv6 Address: FD01::A01:305/64
IPv6 Gateway: FD01::A01:585
IPv4 Address: 10.1.2.205 Subnet Mask: 255.255.0.0
IPv4 Gateway: 10.1.1.1
DNS1: 10.1.5.133
DNS2: 10.1.5.134
DHCP Settings
DHCP: disabled
FQDN: enabled [sentry-ffffff]
Boot Delay: disabled
Static Fallback: enabled
ZTP (0-Touch): enabled (not provisioned)
Network Services
FTP Server: enabled Port: 21
FTP Updates: disabled Port: 21
SSH: enabled Port: 22 Auth: Password, Kb-Int
Telnet: enabled Port: 23
HTTP: enabled Port: 80
HTTPS: enabled Port: 443 Installed Cert: Factory
User Cert: enabled
SSL User Certificates: enabled
User Passphrase: <none>
Uploaded Files: None
SNMPv1/2: enabled Port: 161 TrapPort: 162
SNMPv3: disabled Port: 161 TrapPort: 162
Web Svc API: enabled
SPM Access: enabled