28
Connecting light bulbs or LEDs
· You can choose between light bulbs and
LEDs.
· LEDs: series resistor necessary
· Light bulbs: choose light bulbs that match the
operating voltage
(7,2V = 6V light bulbs; 11,1 = 12V light bulbs)
Connecting Servonaut sound modules
Servonaut sound modules can be directly
connected to the M24 (output sound out). If you
chose with idling (only possible with cruise control)
you can rev the engine (sound) while stationary.
The engine is running at a higher idle speed and
simulates an auxiliary drive. Tap the brake to
switch it off, so the engine runs at normal idle
speed again. The change from forward to reverse
gear is only possible when the motorsound fades
out in the idle run.
Setup your radio for the M24
Left/right
Check if the left indicator blinks when you move
the joystick to the left. If not, reverse the left/right
direction for this channel.
Forwards/backwards with cruise control
Check if the brake lights shine when you brake. If
not, reverse the up/down direction for this
channel.
If the model drives backwards while you steer
forward, switch the motor cables.
Forwards/backwards without cruise control
Check if the reversing light shines when you drive
backwards. If not, reverse the up/down direction
for this channel.
If the model drives backwards while you steer
forward, switch the motor cables.
To Next Page
Loading...