To Next PageTo Next Page
Need help?Do you have a question about the Servonaut M24 and is the answer not in the manual?
General| Motor current (max) | 24A |
|---|---|
| BEC | 5V |
| BEC Current (max) | 2A |
| Number of channels | 1 |
| Weight | 30g |
| Protection | Overload |
Lists key functionalities and specifications of the M24 controller.
Highlights unique driving behaviors and cruise control features.
How to activate and operate turn signals using the joystick.
Method for activating and deactivating hazard warning lights.
Instructions for operating parking and driving lights.
Details the M24's servo output for special functions like trailer legs.
Guides on connecting the M24 to the radio receiver.
Instructions for connecting light bulbs and LEDs to the M24.
Guidance on connecting Servonaut sound modules to the M24.
Steps to configure your radio transmitter for the M24 controller.
Verifying left indicator blinking for correct left/right channel function.
Operating the model forwards and backwards with and without cruise control.
Configuring combined lighting effects for parking and low beam.
Adjusting LED behavior to simulate light bulbs.
Simulating xenon lamp flashing for low beam.
Adjusting the brightness of the turning light.
Adjusting the brightness of the parking light.
Limiting maximum speed and setting its activation range.
Enabling idle mode for sound modules with cruise control.
Selecting PWM frequency for coreless or standard DC motors.
Supporting motor start for smoother acceleration.
Setting maximum acceleration for realistic vehicle handling.
Setting maximum braking power for realistic driving.
Choosing between manual or automatic indicator switch-off.
Enabling or disabling cruise control for driving performance.
Activating warning lights when reversing.
Determining the default position of the servo output.
Automatic voltage monitoring and speed adjustment for battery health.
Connecting M24 to multichannel for light set operation.
Ensuring multiswitch channel compatibility with radio systems.
Mapping controls for sound, speed, light, and multiswitch functions.
Mapping controls for sound, speed, light, and multiswitch functions.
Setting Multiplex radio signal format to UNI/universal.
Ensuring settings are saved by not switching off too early.
Holding the brake after standstill to switch off the controller.
Applying brakes before shifting gears and moving the stick.
Tips for connecting multiple cables to one terminal.
Connecting LEDs with correct polarity and using a series resistor.
Connecting LEDs in series with sufficient operating voltage and resistors.
Avoiding diagonal joystick movements and letting it spring back.
Reduced speed operation with low battery and over-discharge prevention.
Recommendation to use a notchless joystick with return spring.
Correcting reverse running when throttle is opened.
Diagnosing low battery or bad reception causing hazard light blinking.
Improving reception by optimizing receiver placement and antenna.
Addressing reception issues caused by nearby transmitters.
Managing hazard light blinking during strong interferences.
Troubleshooting uphill acceleration issues related to battery or current limiter.
Diagnosing slowdowns due to empty battery or high temperature.
Always switch the radio on before the model.
Always switch the model off before the radio.
Disconnect the battery for long breaks or transport.
Wireless infrared data reception for trailer lighting.
IR transmitter for M and K speed controllers with light sets.
2.4GHz radio system with special functions.
Small multiswitch module for 4 functions.
Servo tester and setup tool for Servonaut products.
Gearbox drive with 12V 360 RPM motor.
Gearbox drive with 7.2V 390 RPM motor.
Low speed high torque motor for truck models.
7V front LED cable harness set.
12V front LED cable harness set.
7V rear LED cable harness set.
12V rear LED cable harness set.
Five motor sounds, speed/situation dependent with turbocharger.
Engine sound generator for truck models, speed/situation dependent.
Protect module from water/oil, avoid foam, check polarity, prevent short circuits.
One-year warranty covering defects, excluding user error or overloading.
