18
6. Remove pieces until the display reads the number of parts you wish to count
out or kit.
7. Press the zero key.
8. Repeat Steps 6 and 7 as many times as needed.
Note: If the average piece weight (APW) is known, you may press the — key, enter
the APW, and press the apw key in place of Steps 3, 4, and 5.
NET TOTALIZED COUNTING
In some applications, when totalizing the number of pieces, it is necessary to check
the gross weight periodically to ensure the capacity of the scale is not exceeded. To
perform net totalized counting, use the following procedure:
1. Press the — then clear keys.
2. Press the zero key and place a container on the pan.
3. Press the tare key.
4. Place a known number of pieces into the container.
5. Enter the number of pieces you have placed into the container.
6. Press the count key.
7. Add pieces.
8. Press the accum key to store the number of pieces in the accumulator register.
9. Press the gross key. The display shows the gross weight.
10. Press the tare key. The gross weight is entered into the tare register. In this
manner, the tare register is used to accumulate the gross weight.
11. Repeat Steps 6-10 until the desired number of pieces has been accumulated.
12. Press the ./rcl key.
13. Press the accum key. The totalized number of pieces is shown.
To Next Page
Loading...
Need help?
General
