28
Note: Your printer is now formatted. To change the print format, simply repeat Steps
1-15 above. The factory default setting prints out all known and available
information. If an I.D. number has been entered, it will always print.
When connected to a computer, if all print formats have been selected to be
off (0), the scale will output "string format" (see Appendix VI).
FORMATTING MINIMUM SAMPLE SIZE
To set a minimum sample size when counting, use the following procedure:
1. Press the — key and enter 2222.
2. Press the setup/cal key. The display will read "CAL PC".
3. Enter the minimum number of pieces to be required.
4. Press the setup/cal key.
Note: To discontinue the Minimum Sample Size feature, repeat Steps 1,2 & 4.
FORMATTING MINIMUM ACCURACY
To set a specific minimum accuracy level when counting, follow this procedure:
1. Press the — key and enter 3333 .
2. Press the setup/cal key. The display will read "CAL AC".
3. Enter the desired accuracy in percent; e.g. 99.9.
4. Press the setup/cal key.
Note: For any given sample, the scale automatically calculates the necessary
number of pieces weighed to achieve a desired accuracy. To discontinue use
of the Minimum Accuracy feature, repeat Steps 1, 2 and Step 4.
SECONDARY PRINT FORMAT FOR BAR CODE LABELS
This secondary print format is available if you want to print to both a serial printer
(such as the 240P or 340P printer) and a bar code label printer. The bar code format
function controls the bar code label produced by a Setra Auto Count
™
200 system.
The format selects the printout of various measured and stored numbers. To format
which fields are to be bar coded, use the following procedure:
1. Press the — key and enter 4444 and press the setup/cal key. The display will read
“CAL bC”.
2. Enter 0 if your scale is connected to a Auto Count 200 (version 2.05 or lower).
Enter 3 if your scale is connected to a Setra Auto Count 200 (version 2.06 or
To Next Page
Loading...
Need help?
General
