EasyManuals Logo

Setra Systems 35CP User Manual

Default Icon
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48
Appendix IX
User Replaceable Components
Under normal operation, it is not necessary to perform any routine maintenance to
your scale other than periodic calibration. However, some users may wish to pur-
chase an extra battery pack for extended operation. With time and wear, it may
become necessary to replace the controller cable. This section describes battery
and cable replacement.
BATTERY REPLACEMENT
To replace the optional battery, refer to Figure 3 and perform the following steps after
removing power from the unit.
1. Turn the scale over so the scale is resting on its pan.
2. Remove the two Phillips head screws on the battery cover. The battery cover is
the left cover. It is opposite the cable replacement cover.
3. Remove the existing battery connector and remove the battery from the cavity.
4. Place the new battery in cavity with the battery wires facing rear of scale.
5. Plug battery connector into receptacle on printed circuit board through opening
in rear of battery cavity.
6. Place battery cover in place, making certain not to catch the wires.
7. Replace the screws.
8. Flip the scale upright and test.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Setra Systems 35CP and is the answer not in the manual?

Setra Systems 35CP Specifications

General IconGeneral
BrandSetra Systems
Model35CP
CategoryScales
LanguageEnglish

Related product manuals