EasyManuals Logo

Setra Systems BL-EL-4100D User Manual

Default Icon
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
5. Perform the necessary weighing procedures on the balance.
6. Press the PRINT key on the balance.
NOTE: If using label stock, the form feed command must be programmed
in User Setups (see Appendix I). When using a printer other than the
CoStar SETRA 250, set the baud rate and parity of your balance to
match the printer (see Appendix I, User Setups to select the print
mode, baud rate and parity).
REPETITIVE PRINTING
It is sometimes desirable to measure weight at fixed intervals of time. One
use of this procedure is evaporation studies. To print out weight at fixed
intervals, refer to SETTING THE PRINT FUNCTION in Appendix I: User Setups.
Once the time interval has been selected proceed as follows:
1. Press PRINT to begin the repetitive printing procedure.
2. Press PRINT again to stop the procedure.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Setra Systems BL-EL-4100D and is the answer not in the manual?

Setra Systems BL-EL-4100D Specifications

General IconGeneral
BrandSetra Systems
ModelBL-EL-4100D
CategoryScales
LanguageEnglish

Related product manuals