18
STEP 5.
nOnEPArI7Y
MODE
TARE
POWER
Press the MODE key to enter the parity menu. The display will read “nOnE” for
no parity. To view the parity menu press the TARE key.
STEP 6.
0.00nOnE
MODE
TARE
POWER
When the desired parity (none, odd, even) is displayed, press the MODE key.
The balance will then return to the normal weighing mode.
ENABLING UNITS OF MEASURE
The UNITS function can be programmed to turn certain weighing units on
or off. To enable or disable certain units of measure, perform the following
procedure.
STEP 1.
TARE
POWER
MODE
FUnC
0.00
Hold down the TARE key then press the MODE key. Release both keys, the
display will read "FUnC".
STEP 2.
MODE
TARE
POWER
UnI7SFUnC
Press the TARE key three times, to display “UnITS” for the units menu.
Note: To escape anytime during this procedure, press the TARE key until
"ESCAPE" is displayed and press the MODE key.
To Next Page
Loading...
Need help?
General
